localhost login: setup
Enter hostname[]: acs-server-1
Enter IP address[]: 209.165.200.225
Enter IP default netmask[]: 255.255.255.0
Enter IP default gateway[]: 209.165.200.1
Enter default DNS domain[]: mycompany.com
Enter Primary nameserver[]: 209.165.200.254
Add\/Edit another nameserver? Y\/N : n
Enter username [admin]: admin
Enter password:
Enter password again:
Pinging the gateway…
Pinging the primary nameserver…
Do not use `Ctrl-C’ from this point on…
Appliance is configured
Installing applications…
Installing acs…
Generating configuration…
Rebooting…
After the ACS server is installed, the system reboots automatically.
Verify that the application has been installed properly by entering show application.
Check the release and ACS version installed by entering show application version acs
Check the status of ACS processes, at the system prompt by entering show application status acs <\/p>\n
<\/p>\n
Password Reset<\/strong> <\/p>\n – Power up the appliance. The console displays:<\/p>\n Welcome to Cisco Secure ACS 5.3 Recovery In my case I used option 4 since I was connected via console. <\/p>\n The console displays: <\/p>\n ————————————————————————- This utility will reset the password for the specified admin username.
– Insert the ACS 5.3 Recovery DVD.<\/p>\n
To boot from hard disk press <Enter>.
Available boot options:
[1] Cisco Secure ACS 5.3 Installation (Keyboard\/Monitor)
[2] Cisco Secure ACS 5.3 Installation (Serial Console)
[3] Reset Administrator Password (Keyboard\/Monitor)
[4] Reset Administrator Password (Serial Console)
<Enter> Boot from hard disk <\/font> <\/p>\n
———————— Admin Password Recovery ————————
————————————————————————- <\/font> <\/p>\n
At most the first five admin usernames will be listed. Enter Ctrl-C
to abort without saving changes and reboot. <\/font> <\/p>\n